Protect Your Pipes From Freezing with Pipe Freeze PRO Heat Tape
Prevent frozen pipes with the best pipe-trace heat tape on the market, packaged in this convenient kit. Our Pipe Freeze Kit includes a designated length of Pipe Freeze Pro Self-regulating heat tape (cable), a roll of fiberglass heat-resistant installation tape and our quick-guide set up and installation manual.
Can I use Pipe Freeze Pro to Prevent My Pipes from Freezing?
Pipe Freeze Pro can be used to prevent pipe freezing on almost all types of plumbing pipe. Different applications and installation techniques will depend on the material, the diameter of the pipe, and the ambient temperature of the environment of which the pipe resides.
Refer to our instruction manual for the best practices for your pipe freeze prevention project.
Questions about Pipe Freeze Pro?
Here are some of the top questions about Pipe Freeze Pro answered. Click the “+” to view the answer. If you don’t see the answer to your question, check below to see more FAQ categories:
You can install Heat Tape on pretty much any type of roof.
This includes, but is not limited to:
- Asphalt Shingle
- Cedar Shakes and Shingles
- Spanish Tile
- Flat Roofs
Depending on the type of roof you have you may need specific roof clips / mounts designed specifically for the material. Check out our Accessory section to see what we have too help with your installation.
Installing our heat tape on your standing seam roof can be very effective in combating ice dam formation. There’s two main products used to install heat tape on your standing seam metal roof: The S-5 SR Heat Tape Clip, and the standard ice dam heat tape clip.
Installing Heat Tape on a Standing Seam Roof with the S-5 SR Heat Tape Clip
The S-5 Heat Tape Roof Clip is a new, patented roof clip design specifically for standing seam applications with a focus on ease of install and effectiveness. It is used in conjunction with the S-5 Base, which needs to be purchased separately. The S-5 base is designed to clamp onto the seam of a metal roof as the S-5 Clip holds your ice dam heat tape into position. Can be set up in a single or dual-clip configuration. (See product page for more info)
Installing Heat Tape on a Standing Seam Roof with Standard Roof Clips
There are specific ways/configurations used when installing heat tape on a standing seam / metal roof using standard heat tape clips. The following (2.6 – figure 16.0 & 17.0) shows a snippet of the HeatTape Pro installation manual showing two different clip configurations, more info can be found in the manual itself: Heat Tape Pro installation Manual
Yes you can.
However, the standard serpentine patterns designed to create water-drainage channels in forming ice don’t really apply to flat roofs, because we don’t have the same directional gravity pulling the water down like we do on a sloped roof.
Each heat tape application on a flat roof can differ based on many factors. The best way to determine a heat tape solution for your flat roof is to contact us, and we’ll help design a configuration that fits the best for your needs. Not only are we Ice Dam and Heat Tape experts, we know a lot about flat and rubber roofs from our sister roofing company in Minneapolis, MN.